Here is a link to everything I used: https://amzlink.to/az0uY1Ga5gTum And here are the steps! ➡️ Fill with an epoxy putty ➡️ Sand smooth with 220 grit ➡️ Sand the rest of the area and stain (if applicable) and add your first layer of top coat. You can also use this method if you’re not refinishing the entire area, just tape off the surrounding area when sanding and skip the first layer of top coat. ➡️ Start building the coverage with the Blendal sticks in layers making sure to seal with a light coat of sprayable lacquer between each layer ➡️ Add a tiny bit of sprayable toner to further blend if needed ➡️ Once dry seal with the oil based top coat of your choice and enjoy your newly repaired furniture! Drop any questions in the comments! *affiliate link*