Learn how to effortlessly assemble Optimum 600XXL Cold Press Juicer with these simple steps. After use and before cleaning, ensure the juicer is in the 'O' position and disconnected from the power source. Remember, the lid must be open for disassembly. Note: The lid MUST be opened for assembly. Place the juicing bowl on the motor base, aligning the position of the spouts and the axle. Firmly push the squeezing auger into the centre of the bowl, ensuring that it touches the bottom; otherwise, the cover cannot be closed. Align the ▲ on the chute with the " " on the bowl and twist it clockwise until it clicks into the safety lock. Make sure that the arrow ▲ on the cover aligns with the Lock graphic on the bowl. Ensure the hopper lid is completely pushed down and clicks closed to activate the micro switch; otherwise, the juicer will not start. Position the juice container and the pulp container under the relevant spouts. Using the 600XXL Juicer: • Connect the unit to the power supply. • Check and ensure that all parts are properly assembled in the correct position. • Make sure the machine is switched off and set to the "O" position. • Ensure that the juice and pulp containers are correctly positioned. • Ensure that the juice spout cover is closed. • Prepare the fruits or vegetables by cutting them into pieces no larger than 5cm x 3cm strips or 5cm x 5cm cubes. • Place the fruit strips or cubes into the chute. • Press the switch to the "-" setting to start the juicing operation. • Use the pusher to gently push the food down. • If any food gets stuck inside the bowl stop the juicer and then switch to the reverse function "R". NOTE: PLEASE DO NOT USE THE JUICER CONTINUOUSLY FOR LONGER THAN 20-30 MINUTES.